How to Operate the GT-KA01-2 Whole Shoes Flexing Tester for Shoe Durability Testing-gester-instruments.com

Catégories

Blog

Nouveau Blog

Mots clés

How to Operate the GT-KA01-2 Whole Shoes Flexing Tester for Shoe Durability Testing October 21 , 2024

How to Operate the GT-KA01-2 Whole Shoes Flexing Tester for Shoe Durability Testing

The GT-KA01-2 Whole Shoes Flexing Tester is an essential machine used in the footwear industry to evaluate the durability and flexibility of shoes under repetitive stress. As the demand for high-quality footwear increases, manufacturers must rely on precise testing equipment to ensure their products meet rigorous quality standards. This article provides a detailed guide on the features, application scenarios, and operation of the shoes flexing tester, helping users maximize the efficiency and accuracy of their testing procedures.

Features and Benefits of the GT-KA01-2 Flexing Tester
1. Acrylic Protective Cover: The Finished Shoes Flex Tester is equipped with a clear acrylic cover that ensures safe operation while reducing noise.

2. Heel Fixture with Linear Slide: The heel fixture uses a linear slide mechanism, allowing for smooth movement with minimal resistance. This design improves the precision of the test and ensures consistent results during repeated tests.

3. Automatic Stop Feature: The Whole Shoes Flexing Testing Equipment allows users to freely set the desired running times for the test, and once the test is completed, the machine automatically stops. This feature enhances convenience and reduces the need for constant monitoring, improving overall efficiency.

Operation Steps
To operate the GT-KA01-2 Whole Shoes Flexing Tester, begin by opening the machine’s cover and removing the cork. Install the cork onto the shoe’s toe cap and securely fasten it. Next, lift the locating pin and push the fixture forward to bring it close to the shoe, then use the fixture to secure the heel. On the left control box, adjust the two working options for the left side of the machine; repeat the same adjustments on the right side. Select the desired flexing angle (e.g., 30°), then use a wrench to adjust the pointer to the appropriate angle. Refer to the parameter sheet to set the corresponding size (e.g., 30° corresponds to 40). Choose either the counting or timing mode based on your requirements and set the relevant parameters. After completing the settings, click "Return," then make sure to press "Zero" before starting the test. The machine will automatically stop once the preset data is reached. Afterward, remove the test sample and observe the results.

Maintenance and Care
Proper maintenance is essential for keeping the GT-KA01-2 Whole Shoes Flexing Testing Equipment functioning efficiently over time. After each use, it's important to clean the surface of the machine, removing any dust or debris that could interfere with operations. Additionally, regularly inspect the mechanical components for wear and tear, replacing any worn parts as needed to maintain the machine’s precision and reliability. Routine calibration is also recommended to ensure that the tester continues to deliver accurate results.